Skip to main content
a9-1

Easily Remove Trim Without Causing Damage

There’s an art to removing trim, whether you need to take off a few pieces of baseboard to install a built-in bookcase or remove all the trim in a room for a remodeling project. You have to do it properly to avoid damaging the walls, and the trim if you plan to reuse it. In this story, we’ll show you how to do the job and keep the collateral damage as low as possible.

Slice the paint first

This tip applies mainly to painted trim. It’s common for moldings to be stuck to the wall, or for adjacent pieces of trim to be stuck together, either from caulk or years of built-up paint. If you don’t slice through the caulk or paint, the trim will be harder to remove, but more important, the wall or trim may get damaged. Use a sharp blade in a utility knife to cut along the joint to separate the trim. Be prepared to change blades frequently because dried paint is hard to cut and tough on blades.

Start with a putty knife

Before you can start using a pry bar, you have to coax the trim loose to create a crack for the pry bar to fit into. The best tool for doing this is a stiff, sharp scraper blade. A painter’s 5-in-1 tool also works well. Don’t be afraid to tap the end of the tool with your hammer to drive it behind the molding. Then wiggle and push until you’ve created a crack big enough for the pry bar.

Protect the wall with a putty knife

Positioning a wide putty knife or thin piece of plywood between the pry bar and the wall helps spread out the force and reduces the chance that you’ll damage the drywall or plaster.

Buy a small molding bar

A small molding pry bar with a wide, sharp blade is good for removing smaller trim and for starting to pry off larger pieces of trim. These little pry bars have the advantage of fitting easily into your tool belt. Of course, you’ll probably also need a medium-size pry bar for removing large trim or wide baseboard. The pry bar shown here is made by Stanley and is called a precision molding bar. You can buy a pry bar like this (about $10) at home centers and hardware stores.

Start at the end

It’s easier to remove trim if you start at one end. That way you can use leverage on the trim to your advantage, pulling out on the loose end to help loosen nails along the way. Be careful, though. It’s also easy to overdo it and break trim by bending it out too far.

Pry against studs when removing baseboard

If you pry against the wall where there’s no stud, the pry bar might go right through the drywall. You can avoid this problem by prying only where studs are located. An easy way to find studs is to look for the nails along the top of the baseboard. These are usually driven into studs, so prying above them should be safe. If you can’t spot any nails through the paint, reach for the stud finder

Cut nails if the trim is hard to get off

Occasionally you’ll run into a situation where the trim is trapped behind another piece of trim or some other woodwork, preventing you from prying it away from the wall, or is simply difficult to pry off. In these cases, slipping a hacksaw blade behind the trim and cutting the nails will free it. For this task, you can use a hacksaw blade in a holder, a reciprocating saw with a metal-cutting blade or an oscillating tool with a metal-cutting blade.

Pull nails through the back with a nippers

Removing trim nails by pounding them out with a hammer usually causes splintering and damage to the face of the molding. To avoid this, pull the nails from the back of the molding. Grab the nail at the base with an end-cutting nippers and roll the nippers along the curved jaw to pull the nail. Don’t squeeze the jaws any more than needed or you’ll cut through the nail. If you don’t have a pair of nippers handy, a locking pliers (Vise-Grip is one brand) will also work.